Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate Firmware V1.18 (RC3 UPDATE)
#55
"Clone Pattern" seems to be broken in RC3!

The selecting of patterns is done on the row below what it should be.

To clone, say, pattern 2 to 3 - you actually need to go to the "to" row, and press right 2 times, then go back up to the "from" row and the value updates.

Then you need to go to the "clone now" row and press right 3 times, then go up to the "to" row, and the value updates!
Reply


Messages In This Thread
RE: Release Candidate Firmware V1.18 (RC3 UPDATE) - by depaffect - 02-17-2019, 08:31 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)