Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate Firmware V1.18 (RC3 UPDATE)
(02-17-2019, 08:31 AM)depaffect Wrote: "Clone Pattern" seems to be broken in RC3!

The selecting of patterns is done on the row below what it should be.

To clone, say, pattern 2 to 3 - you actually need to go to the "to" row, and press right 2 times, then go back up to the "from" row and the value updates.

Then you need to go to the "clone now" row and press right 3 times, then go up to the "to" row, and the value updates!

Hey thanks. Oh i think this is an abandoned function! I will remove that in the next version.
You can more simply clone a pattern in the sequencer screen by pressing SHIFT+OK and it will be cloned into a new pattern.

I didn't touch that since quite a time i think, so it has been in there like this since earlier versions i guess.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile

Messages In This Thread
RE: Release Candidate Firmware V1.18 (RC3 UPDATE) - by XORadmin - 02-17-2019, 08:42 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)