Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Octave/Interval transpose
#1
Okay, I'm still pretty new at the Nerdseq; sorry if this is too basic. I haven't been able to figure out how to do a very simple thing: select a block of notes and move them up/down an octave or some other interval. I know there's gotta be a way to do this (without FX or Table please), but I can't seem to find anything in the manual!
Reply
#2
FX - basenote
Reply
#3
Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
Reply
#4
(07-29-2019, 08:34 PM)Barney Rubble Wrote: FX  - basenote
Yeah, I was hoping to not have to use FX or Table. It's a little awkward that you can't just change a block of note names in the notes column so that you can actually, you know, SEE the new note names after you transpose. Guess if I want that, I just have to change the notes one by one; Ok for a few notes, but much more than that gets a little tedious. Thanks for the reply!

(07-29-2019, 08:51 PM)ianski Wrote: Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
Yay! That's what I'm looking for, thanks!  Smile
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)