XOR Userforum › Products › NerdSEQ › General Questions v
Octave/Interval transpose

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Octave/Interval transpose
atimbral Offline
Junior Member
**
Posts: 18
Threads: 5
Joined: Jul 2019
Reputation: 0
#1
07-29-2019, 08:23 PM
Okay, I'm still pretty new at the Nerdseq; sorry if this is too basic. I haven't been able to figure out how to do a very simple thing: select a block of notes and move them up/down an octave or some other interval. I know there's gotta be a way to do this (without FX or Table please), but I can't seem to find anything in the manual!
Find
Reply
Barney Rubble Offline
Member
***
Posts: 136
Threads: 28
Joined: Oct 2018
Reputation: 3
#2
07-29-2019, 08:34 PM
FX - basenote
Find
Reply
ianski Offline
Sunbusta
***
Posts: 55
Threads: 15
Joined: Jun 2019
Reputation: 2
#3
07-29-2019, 08:51 PM
Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
Find
Reply
atimbral Offline
Junior Member
**
Posts: 18
Threads: 5
Joined: Jul 2019
Reputation: 0
#4
07-29-2019, 09:09 PM (This post was last modified: 07-29-2019, 09:13 PM by atimbral.)
(07-29-2019, 08:34 PM)Barney Rubble Wrote: FX  - basenote
Yeah, I was hoping to not have to use FX or Table. It's a little awkward that you can't just change a block of note names in the notes column so that you can actually, you know, SEE the new note names after you transpose. Guess if I want that, I just have to change the notes one by one; Ok for a few notes, but much more than that gets a little tedious. Thanks for the reply!
(07-29-2019, 08:51 PM)ianski Wrote: Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
Yay! That's what I'm looking for, thanks!  Smile
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)