Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate Firmware V1.20 RC5
#19
Live Inputs x and y cursor on separate cv inputs one can move the cursor remotely and use stop and start tracks - It makes me think of the etch a sketch ;-)

Re the sample ones -:
Empty pattern
Load some samples into the slots - run the pattern
Live on
Input 1 gate - put in a square LFO into CV in 1
Input 2 pitch - put a source voltage that you can vary into CV in 2
Input 3 Slot - put a source voltage that you can vary into CV in 3

With this setup I'm able to select different samples in the slots change the pitch and gate the samples. Anyways this should get you started and give you some ideas. :-)

I just discovered the sequencer does not need to be running to make the sample stuff work......this is so cool
Reply


Messages In This Thread
RE: Release Candidate Firmware V1.20 RC3 - by Mat - 08-27-2019, 10:47 AM
RE: Release Candidate Firmware V1.20 RC3 - by Mat - 09-03-2019, 10:56 AM
RE: Firmware V1.20 Release Candidate - by ehr - 07-26-2019, 04:01 PM
RE: Firmware V1.20 Release Candidate - by modbang - 07-26-2019, 07:38 PM
RE: Firmware V1.20 Release Candidate - by skybox - 07-26-2019, 07:50 PM
RE: Firmware V1.20 Release Candidate 2 - by Barney Rubble - 07-29-2019, 08:23 AM
Lockup loading proj. with 1.20 RC - by StateAzure - 08-05-2019, 04:39 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)