Release Candidate Firmware V1.20 RC5

[XORadmin]

Live  Inputs  x and y cursor on separate cv inputs one can move the cursor remotely and use stop and start  tracks -  It makes me think of the etch a sketch ;-)

Re the sample ones -:
Empty pattern
Load some samples into the slots - run the pattern
Live on
Input 1 gate  - put in a square LFO into CV in 1
Input 2 pitch - put a source voltage that you can vary into CV in 2  
Input 3 Slot - put a source voltage that you can vary into CV in 3

With this setup I'm able to select different samples in the slots change the pitch and gate the samples. Anyways this should get you started and give you some ideas. :-)

Not to forget sample offset, so you can also do some slicing of the samples