Release Candidate Firmware V1.20 RC5

[XORadmin]

Hi, I installed 1.20 RC2 and loaded a save-file from an older version (1.16 I think).

In the Automate screen there are some un-allowed values for some automation destination slots (see screenshot) and when I try to adjust these values pretty soon I will get an error as shown.  The Nerdseq locks up completely and doesn't respond to any keypresses.

If I clear the slot with DELETE it goes back to -- and I can then adjust it within the legal range with no problems.

When the error comes then it is a detected crash.
Please add the project file so i can check where the weird automation values come from...when i’m back.