Release Candidate Firmware V1.20 RC5

[XORadmin]

Wow this update (and the last one) really takes this module into another dimension...

I really agree!

Some minor trouble...

For the manual CV IN callibration (awesome!):
When you are in the calibration, you go down with the selector up to CV input, it opens all the gates (1,2,3,4,5,6) in passing and some do not close the blow difficult to calibrate, you have to unplug everything.  Someone confirms?

Transposition:
If you calibrate your CV IN properly  the (live) transposition by CV of all tracks (except those that are disalowed) works perfectly.
But if you want to do the same thing via automations setting well it also works but the callibration of CV IN does not seem to be taken into account, there is always about 1/4 of offset tone. Someone confirms too?

I hope my english google is understandable ...
And again this update is great, thank you very much

I just added the page up/down buttons for the calibration screen. So you can jump directly between the sections without the unwanted gate opening when passing the trigger parts.

The CV input for the automation is not calibrated to any scale at all at the moment. It will only also get a range and offset selection in the future so one can finetune the input for the automators themselves. But not for this release.