Release Candidate Firmware V1.20 RC5

[XORadmin]

Hi, I installed 1.20 RC2 and loaded a save-file from an older version (1.16 I think).

In the Automate screen there are some un-allowed values for some automation destination slots (see screenshot) and when I try to adjust these values pretty soon I will get an error as shown.  The Nerdseq locks up completely and doesn't respond to any keypresses.

If I clear theH slot with DELETE it goes back to -- and I can then adjust it within the legal range with no problems.

Hey Grib,

would you mind sending me the project file so i can test it and fix the issue?

Hey, yes!  Sorry I'm out of town a few days but I will send it to you as soon as I get back to nerd central.

Ok, sorry for the delay.  I'm attaching the file that causes this problem.  I had been playing with the automation LFOs before saving the file but I believe they were disabled when saved.

Please attach!