09-23-2019, 07:26 PM
(09-23-2019, 12:53 PM)XORadmin Wrote:(09-10-2019, 06:40 PM)grib Wrote:(08-28-2019, 04:42 PM)gr ib Wrote:(08-26-2019, 11:37 AM)Hei XORadmin Wrote:(08-06-2019, 07:51 PM)grib Wrote: Hi, I installed 1.20 RC2 and loaded a save-file from an older version (1.16 I think).
In the Automate screen there are some un-allowed values for some automation destination slots (see screenshot) and when I try to adjust these values pretty soon I will get an error as shown. The Nerdseq locks up completely and doesn't respond to any keypresses.
If I clear theH slot with DELETE it goes back to -- and I can then adjust it within the legal range with no problems.
Hey Grib,
would you mind sending me the project file so i can test it and fix the issue?
Hey, yes! Sorry I'm out of town a few days but I will send it to you as soon as I get back to nerd central.
Ok, sorry for the delay. I'm attaching the file that causes this problem. I had been playing with the automation LFOs before saving the file but I believe they were disabled when saved.
Please attach!
Ooops, sorry! I thought I did, but I see that I didn't.
RATS.NRD (Size: 428,8 KB / Downloads: 4)