Just today received my more CV expander - I’m stoked! I’m starting by using it to add modulation outputs into various elements of my Akemie’s Taiko module. I have it set up on Track 5 and have a couple of questions:
One, I don’t understand the difference between “Track CV 5” and “Loc CV 5” (and similar Track X versus Local X Mod). These seem the same to me, but there must be some difference I don’t understand.
Two, if I want to send note information as well as a trigger on the same step, what I’ve done is assign columns/destination 1 and 2 each to Track CV. One has the note info and the other, I use TT2 (just triggers). Just want to start off with good practice, and to see if this is the best way to go about it?
Thanks!
One more question/issue! I’m trying to send modulation from the CV16 to a parameter on my Akemie’s Taiko called Release 2. When I send an offset from my MATHS, 10 v, it increases the release as expected. When I send a Mod Value (either a high note like C-9 or the highest value FFD) from Ext CV 4 to the same Release 2, nothing changes (I have the switch to the right, which should be 0-10 v). Not sure what I’m doing wrong here? Edit: Tested with an LFO and it seems to be modulating fine.
One, I don’t understand the difference between “Track CV 5” and “Loc CV 5” (and similar Track X versus Local X Mod). These seem the same to me, but there must be some difference I don’t understand.
Two, if I want to send note information as well as a trigger on the same step, what I’ve done is assign columns/destination 1 and 2 each to Track CV. One has the note info and the other, I use TT2 (just triggers). Just want to start off with good practice, and to see if this is the best way to go about it?
Thanks!
One more question/issue! I’m trying to send modulation from the CV16 to a parameter on my Akemie’s Taiko called Release 2. When I send an offset from my MATHS, 10 v, it increases the release as expected. When I send a Mod Value (either a high note like C-9 or the highest value FFD) from Ext CV 4 to the same Release 2, nothing changes (I have the switch to the right, which should be 0-10 v). Not sure what I’m doing wrong here? Edit: Tested with an LFO and it seems to be modulating fine.