table trouble

[depaffect]

I'm getting a bit confused with tables!

They don't seem synchronised with the main clock very well at all.

Eg, I have a table set to INT TICK, SPEED 06, RESTART that I put at the very top of a pattern

However it seems to be firing off a step too late(ish). I've attached a video to demonstrate. Also it seems a bit sloppy so that occasionally you hear the fourth row for a split second before the NOTE OFF turns off the gate, but usually not at all. But really you should hear the fourth row of the table in its entirety, since the pattern has the gate open for 4 steps.

Am I missing something here? 

[skybox]

I tested out mine with the same setup as yours and I had no problem. What are your CV/Gate going out to?

[XORadmin]

Depaffect is right. In this situation there is a slight timing issue on table start. This is known and discussed here already and is on my fix list for after the expanders and midi was implemented. So the schedule is for the next main release now.

[depaffect]

Ah good! Sorry I did not find when searching!

[SB-SIX]

I've tried this, and it seems this issue still remains in 1.21. Endless tables run fine, restart and oneshot are all over the place (notes starting to late, skipping notes). It was not in the releasenotes so I guess it will have to wait for the next release

[XORadmin]

You are correct. If it's not in the release notes, then it didn't change ;-)