The Launchpad Thread

[XORadmin]

Hi there fellow nerds.

I've dusted off my barely used launchpad mini Mk2. but when connected and configured both the nerdseq and the LP just glitch out erratically. I've read the manual and forums but i'm a bit puzzled and need some help.  Midi Channel 1 set to Launch pad mini. nothing on midi channels 2-4. Midi routed to and fro via an iconnect MIO4. Nerdseq firmware 1.27C.

Are others using the same firmware successfully with their launch pad mini mk2?

The LP mini works as expected when connected to computer.

Any suggestions?

The last time I checked it it was working well here. The difference here is that I used the Retrokits rk005, maybe it is a setting in your midi controller?
I will give it a go this weekend and let you know

To my knowledge there aren't really any settings/modes on the LP mini mk2 other than device ID (set to 1) and low/full power which doesn't effect the issue.

I've gone through every page of the iConfig to make sure there are no unwanted midi routings/feedback.

I checked today again with the launchpad mini and it works well. I can see in your video a different version and it seems like a very old one, too. Maybe these got a different button layout?

I use this one:
https://novationmusic.com/sites/novation...0-2670.png