|
Automator description on the pattern screen
|
03-03-2020, 10:28 PM
did I imagine this or did the pattern commands for the automators used to show up on the bottom of the pattern screen?
so I could tell what command was START/STOP/RESET etc. that doesn't seem to happen now.. 
03-03-2020, 10:39 PM
It works here. Select the good slot and be sure the LFO is also used in this slot.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help! 
03-03-2020, 10:49 PM
ok got it working... I must have done something wrong.
any chance we could have the reset command work when the LFO automator is in tick or pattern mode? at the moment it only works in free or slow mode.
03-03-2020, 10:53 PM
(03-03-2020, 10:49 PM)theotteryears Wrote: ok got it working... I must have done something wrong. No it doesn't work like that. If in tick or pattern it is coupled 1:1 to the mainclock. There is no reset here. One LFO iteration is always starting with step/tick 1 and ends with the last step/tick
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
|
|
« Next Oldest | Next Newest »
|
