Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Firmware V1.23A
#31
You did not hit SHIFT+OK?
If so, then hitting SHIFT+OK again switches back.
Reply
#32
I was hitting SHIFT+DOWN (cursor keys) to edit the velocity values and my finger must have slid between the SHIFT and OK buttons, pressing them both to do the accidental SHIFT+OK. Since I've never used SHIFT+OK on the velocity column before I didn't know what was going on. I do know though. All is good.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)