LFO Behaviour

[hima]

I'm not getting the kind of results I would expect. Might be my own confusion... 

I'm using the scope in o_C to confirm output results. I checked PNW and I get 0V- 5V, as I would expect. So the issue is not with my o_C.


The default LFO setting (routed to 01 in the matrix) is giving me a constant -2.4V. That's with the switch to the left.
With the switch to the right, the LFO swings from 0 to around +1.35V. 

If I adjust AMP to max (F7), switch left gives me -2.4V to +0,12V.
Switch right: 0V - 5,20V.

What black magic must be employed to get a -5 to +5 modulation? And I understood I'd be able to get +10 out of this thing. Not true?

As an aside, on the sequencer screen I see no modulation in the rectangle case to the right of the screen. 

  Please help.

[XORadmin]

The Automators are added to the current value of the output. And they run bipolar around that then if the offset is 0.
You either got to set the output to 5 volt then or you put the offset of the lfo to max. Then you can get a nice -5/+5 or 0 / 10 volt swing when amp is on F7.

[hima]

Thanks for the quick reply. I just realised the o_C can only report a minimum or -2,4V and a max of around +6V. That definitely did not help my confusion...