Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate Firmware V1.24 RC12
#9
(02-07-2021, 08:58 AM)XORadmin Wrote:
Quote:sak-rwsd

I’ve finally set up my MIDI a bit more on the new beta-firmware.  Now I’m sequencing a pair of mother 32’s, as well as sequence two pads chromatically on the bitbox, all on one MIDI track (it’s been amazing to be able to overrule the MIDI channel!).  

When I stop my sequence and try to noodle out another using my Arturia Keystep or the keyboard on the Mother 32 itself, it plays the desired note but immediately after, it repeats the last note that was played on the pattern sequence.  I’ve tried to Kill the note and use the note off [ ] but this doesn’t make any difference.  

I’m sure it’s something obvious, but I don’t understand.  Thanks for any advice!

I moved this here since it is related only to the beta release.
I'm going to play around with this a bit more, but no one else of the betatesting mentioned this issue yet. Do you have this also with the regular version and only one midi synth connected? And what is the setting of the midi recording in the track setup?

Hi Thomas, I didn’t have my Moog synths connected before this.  I had tried CV, but not MIDI.  I’ve rerouted my whole setup as of yesterday and am using a iConnectivity MIDIConnect, so have a lot of new MIDI connections as I’m trying a fully DAW-less setup for the first time, incorporating pedals and such as well.  

In terms of the track setup, I have MIDI Channel 1-8, set up as Track Record 1-8, respectively.  Track 6 is a MIDI track and I can choose MIDI Channel 6 on my Arturia Keystep and depending on what I choose on the “Record Columns” in the individual track setup, I can use the Keystep to play the different notes on the MIDI track, that in term go to a couple of Bitbox pads played chromatically (MIDI channel 7 and 8) , and then the Mother 32 which is listening on MIDI channel 1 (and which is the overrule for column 2 - MIDI channel 1).

I feel like it recording fine for the first sequence I recorded into a pattern.  But perhaps I didn’t notice, as I had it all running through pedals and a Hologram Electronics Microcosm.  Now, when I have everything off except for the Moog, it just plays the note I play and then a second note which is the last note played in the NERDSEQ sequence.  I can change the second note by stopping in different places in the pattern.

Sorry, not sure if that is relevant info or not, just trying to be thorough and still wrapping my head around all this!
Reply


Messages In This Thread
RE: Release Candidate Firmware V1.24 RC2 - by sak-rwsd - 02-07-2021, 10:55 AM
RE: Release Candidate Firmware V1.24 RC8 - by mgd - 02-23-2021, 06:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)