Release Candidate Firmware V1.24 RC12

[XORadmin]

sak-rwsd

I’ve finally set up my MIDI a bit ...

I moved this here ...

Hi Thomas, I didn’t have my Moog synths connected before this.  I had tried CV, but not MIDI.  I’ve rerouted my whole setup as of yesterday and am using a iConnectivity MIDIConnect, so have a lot of new MIDI connections as I’m trying a fully DAW-less setup for the first time, incorporating pedals and such as well.  

In terms of the track setup, I have MIDI Channel 1-8, set up as Track Record 1-8, respectively.  Track 6 is a MIDI track and I can choose MIDI Channel 6 on my Arturia Keystep and depending on what I choose on the “Record Columns” in the individual track setup, I can use the Keystep to play the different notes on the MIDI track, that in term go to a couple of Bitbox pads played chromatically (MIDI channel 7 and 8) , and then the Mother 32 which is listening on MIDI channel 1 (and which is the overrule for column 2 - MIDI channel 1).

I feel like it recording fine for the first sequence I recorded into a pattern.  But perhaps I didn’t notice, as I had it all running through pedals and a Hologram Electronics Microcosm.  Now, when I have everything off except for the Moog, it just plays the note I play and then a second note which is the last note played in the NERDSEQ sequence.  I can change the second note by stopping in different places in the pattern.

Sorry, not sure if that is relevant info or not, just trying to be thorough and still wrapping my head around all this!

That sounds quite complex for me right now. Can you reduce this to the one issue (like turning all midi channels off which are not related) and save the project, add it here and explain what i need to do to get the same result?