Release Candidate Firmware V1.24 RC12

[XORadmin]

Bug - when in midi FX - Control Preset - and changing the value quickly (holding down button) the Chn to the right of the Val: ### does not refresh properly. goes between Chnnnnn and Cn (depending on which way you are going with the values). Visuals only. Does not do it when editing the Chn parameter when Control Preset set to Program Change.

Oh it took me a while to be able to reproduce it. It seems your key repeat is set to a very low value and the status bar drawing is slower than that, so it draws only a few letters until the value is being changed and it starts again.
I do this actually to spread the drawing and be sure that all important timings are rock solid and stable. I will see if I can adjust it a little bit so it would work also with the fastest key repeat times. But only if it doesn't affect performance. In the end all is drawn well.