Release Candidate Firmware V1.24 RC12

[XORadmin]

New firmware sounds great! Can someone explain a bit about how the add / sub / mul / div stuff works? Is this to allow a version of 'relative' values for parameters? So what I'm wondering is can you for example use subtract in a table to act as an envelope by looping it? So put an FX in for say volume. The on the table use sub, loop it fast and it will go to zero? Any other cool uses of it? It seems a powerful improvement. 

Sorry if this is a basic question, but I don't have the nerdseq yet (waiting for the portable)! I've been watching videos of the M8 tracker, which I believe always has relative fx values, so you can put volume in teh tablee and loop it and it will not reset the volume to teh given value but subtract it or add it to the current value.

Check the pre-manual about how to use it. But basically it says add value X to the last used FX function from an colum. And if you use it from a table, you can have fast transisions of it.

As a small note about the portable, I think this will not happen until next year. Mainly it is impossible to produce it. You probably know about the shortage of components and lead times of 1 year +. This is what I also have to deal with.

I think the M8 would be for sure a good option for now since it is available soon. I can't guarantee anything. as mentioned I will finish the expanders first and get fully back to the portable after that. But then it will surely look worse in the IC market.